Wet Dungeon Exits

This set of 3D-printable STL models continues the Wet Dungeons line of watery pools and streams for dungeon layouts.  Once again, it includes models for two styles of wet dungeons, one with a brick edge and one with a rougher natural edge.  These models include water flowing through various doors, archways, and wall cracks, connecting pools in adjacent rooms.  They can be mixed with other Wet Dungeons sets to make more elaborate layouts.

Sample layout with Wet Dungeon Exits (along with pieces from Wet Dungeon Floors, Wet Dungeon Walls, Wet Dungeon Walls 2 (Brick), Wet Dungeon Walls 2 (Natural), and the FDG Dungeon Starter Set):

Sample layout

Thumbnails of models included in this set:

Thumbnails of models in this set

Recommended Print Settings:

  • Layer Size: 0.15mm, or 0.1mm for finer detail
  • Infill: 10% for all models recommended, especially thin posts and door frames
  • Top/Bottom Layers: 6 (or 0.9mm if using a different layer size than 0.15mm)
  • Side Shell Count: 2 (or 0.8mm if using a different nozzle size than 0.4mm)
  • Raft/Brim/Supports: none

Related Sets:

  • Wet Dungeon Floors — the base floors with both brick and natural styles
  • Wet Dungeon Floors 2 — more natural floors to add variety to your Wet Dungeon layouts
  • Wet Dungeon Walls — wet dungeon floors with adjacent walls, posts, and corners
  • Wet Dungeon Walls 2: Brick — more wall and post combinations, wet ruined walls, and more
  • Wet Dungeon Walls 2: Natural — more wall and post combinations, wet ruined walls, and more
  • Wet Dungeon Walls 3 — dungeons walls on the expanded selection of natural floors
  • Wet Dungeon Elevation — bring new levels to your Wet Dungeon layouts!

This product is produced by Fat Dragon Games and is priced at $12.99

CHECK IT OUT

This is an affiliate post