Enhanced 2×1" Dungeon Walls

This set of 3D-printable STL models was born when I tried to model a multi-level fortress with stairs near the inside walls and some 5″ wide rooms on the lower level.  FDG Dungeon Expansion 11 has 2×1″ models that would work, except they only have clip slots on the long side and I needed clip slots on the short edges too.

Thus, this set contains versions of the 2″x1″ floor and walls from FDG Dungeon Expansion 11 and FDG Wide Wall Set on bases that have clip slots on all four sides, like this:

Sample piece with four clip slots

Here’s a sample layout where the clip slots on the short ends of the pieces are required:

Sample Dungeon Layout

Models included in this set:

Models included in this set

Recommended Print Settings:

  • Layer Size: 0.15mm, or 0.1mm for finer detail
  • Infill: 10% for all models recommended, especially thin posts and door frames
  • Top/Bottom Layers: 6 (or 0.9mm if using a different layer size than 0.15mm)
  • Side Shell Count: 2 (or 0.8mm if using a different nozzle size than 0.4mm)
  • Raft/Brim/Supports: none for most pieces; brim may be helpful for T roof if there are any adhesion issues

Related Sets:

This product is priced at $5.99

CHECK IT OUT

This is an affiliate post