Additional 2×1" Dungeon Walls

Once I started working on a selection of 2×1″ walls for the Enhanced 2×1″ Dungeon Walls set, I realized there were only a limited selection of 2×1″ models available.  This set of 3D printable STL models provides eleven all new 2×1″ tiles (each on a four-slot base) to complement the existing selection.

Models included in this set:

Models included in this set

Recommended Print Settings:

  • Layer Size: 0.15mm, or 0.1mm for finer detail
  • Infill: 10% for all models recommended, especially thin posts and door frames
  • Top/Bottom Layers: 6 (or 0.9mm if using a different layer size than 0.15mm)
  • Side Shell Count: 2 (or 0.8mm if using a different nozzle size than 0.4mm)
  • Raft/Brim/Supports: none for most pieces; brim may be helpful for T roof if there are any adhesion issues

Related Sets:

  • Enhanced 2×1″ Dungeon Walls — the original selection of FDG 2×1″ walls, except mounted on a 4-slot base for situations where pices must be attached via the short ends


This product is priced at $9.99

CHECK IT OUT

This is an affiliate post