Humanoid Hammerhead Shark RPG Miniature for 3d printing (STL)

This 3d model were sculpted :lang=”en-us”>especially :lang=”en-us”>for 3d printing,The model scale is 1/56 ,which translate in a 32 mm height for an avarage human,but as it is a monster you can find it a little bigger or smaller than an avarage human. but you always can scale it up or down as you wish. Its included : One version without supports, one pre-supported 3d printing tested version…

This item is produced by Futurart 3D

Check it out!

This is an affiliate post.